Plate heat exchanger interface form

April 08, 2024

1. Flange interface, in terms of appearance, has two types: round flange and square flange. The round flange interface form is widely used and is also the most common one. Collisions will occur between the round flanges of some small models of heat exchangers, so square flanges of the same size will be installed.

2. The looper flange interface is often used in special working conditions, such as replacing a titanium flange. Because the titanium flange is small and difficult to make, it is usually a titanium flange looper flange plus a 316L flange. In this case, the medium flowing through the medium is made of titanium, which can protect the plate exchanger from corrosion.

3. Threaded interface, also known as wire connection and threaded connection. Some smaller models of heat exchangers cannot be equipped with flanges, so threaded interfaces will be used, or threaded interfaces are commonly used in food-grade heat exchangers.

4. The quick-connect interface has a clamp connection, also called a groove connection, which serves as a connection seal. Grooved connection pipe fittings mainly consist of three parts: sealing rubber rings, clamps and locking bolts. Used in working environments with high hygiene requirements, such as food, pharmaceutical, chemical and life science industries.

The above is the Plate heat exchanger interface form we have listed for you. You can submit the following form to obtain more industry information we provide for you.

You can visit our website or contact us, and we will provide the latest consultation and solutions

Share to:

Send Inquiry

Previou:Application of cast fin plate air preheater in heating furnace of refining equipment

Next:Heat exchanger sealing gasket structural features