The connection method of the detachable plate heat exchanger is very important, you should pay attention to these

The detachable Plate Heat Exchanger generally has four ports, usually on the same side, or two ports on the opposite side, which is related to the process arrangement. Of course, there will also be multiple ports, such as a three-stage configuration, three media for heat exchange...

The detachable plate heat exchanger generally has four ports, usually on the same side, or two ports on the opposite side, which is related to the process arrangement. Of course, there will also be multiple ports, such as a three-stage configuration, and three media for heat exchange, then another port needs to be opened on the side.

The connection methods of detachable plate heat exchangers generally include Flange connection, stainless steel bush connection, rubber bush connection, threaded pipe connection, food grade quick connection, etc., depending on the different needs of customers. When connecting piping to the heat exchanger, make sure that the piping does not put any pressure or strain on the heat exchanger. Causing the piping system to stress or strain the heat exchanger. Heavy plumbing needs to be supported. This will prevent gravity from acting on the heat exchanger.

Always install a flexible connection on the driven unit to prevent vibrations on the heat exchanger. These flexible connections also prevent expansion of pipework due to temperature effects. These flexible connections also prevent the pipework from expanding over the heat exchanger due to temperature effects. These flexible connections need to be installed longitudinally on the plate pairs. The pipework needs to be thoroughly cleaned and flushed prior to connection to the heat exchanger. Always install vents on both sides of the heat exchanger. For proper ventilation, the vent should be installed at the highest point in the direction of media flow (preferably on the air container). Highest point in the direction of media flow (preferably on an air container). To allow the heat exchanger to be opened when necessary, shut-off valves should be provided at all connections. To allow the heat exchanger to be opened when necessary, shut-off valves should be provided at all connections.

Threaded pipe connections, make sure these connections don't spin while fitting the pipe work. It may damage the spacers on the starter board. You need to "peer" the connection! If there is a rubber gasket at the connection, the gasket will act as a gasket for the flange. Bolt the connection flange directly to the end plate using the drilled and tapped holes provided. Tighten the bolts evenly -- do not overtighten, as this may strip the threads cut into the framing boards. If a loose back plate is installed on the heat exchanger, a suitable gasket will be required to seal the flange. Unless otherwise stated, the liquid circuit shall be connected so that it flows through the heat exchanger in the opposite direction (counter-flow). If the connection is not marked, please refer to the contract drawing or quotation for details.